Eufy Doorbell Brick Extension - 9/16in Wide Base, Offset Over Brick

This mount is a brick extension for all models of Eufy Doorbells (But leave a note of which model you have - I do have a few models that I have sepecific brackets for that fit better). IT CAN BE WIRED or WIRELESS. In cases where the doorbell is located behind a thick brick wall or other obstruction, the extension can be used to move the button or doorbell to a location where it is visible and opposite the door.  It is available in various extension lengths.   If you cant mount your doorbell flat, or if something is in the way of the view, you can use this mount to correct it.   These mounts allow for wires to pass through the center. (PICTURE OF DOORBELL MAY NOT MATCH THE DOORBELL MODEL SHOWN ON THE LISTING - DOORBELL NOT INCLUDED, THIS LISTING IS MADE TO FIT THE DOORBELL MODEL IN THE TITLE OF THIS LISTING ONLY)

This is made to put the doorbell past the bricks if your doorbell is mounted to trim.  It offsets the doorbell over the bricks and away from the door.  So if doorbell is too close to the swing of the door, this is what you will need. 

 This Mount fits this Doorbell found on Amazon (affiliate link below)

https://amzn.to/3u1DlLP

Eufy S330 Dual Camera Doorbell Eufy E340 Dual Camera Doorbell Eufy S220 Single Camera Doorbell Eufy C210 Single Camera Doorbell

This mount is 9/16in wide, and will fit in most spots.  The doorbell will offset away from the door and is reversible to fit on the left or right side of the door.   The wires can pass on the inside of the mount.  I have additional wires and wire nuts if needed for the extra length. This brick extension cannot fully offset the doorbell, message me about a full offset option.  It will depend on the model you have and the cost will be slightly higher.

NORMAL COLOR is Black, if you need to purchase a different color, there will be a color change request listing to change the color.

Be sure to send me a picture of your doorbell and where you want to mount it.    Message me by email at shop@doorbellmount.com or text me at 318-759-7425.  

All my mounts have holes to allow for wire passthrough.

****While 3D printing provides really good production quality parts, there are often imperfections that may be found on the prints. These do not impair the function and rarely affect the aesthetics. But if your not happy with the quality, please text, email, or message me before leaving a review.