Ring Wired Doorbell Plus Formally Ring Pro (not pro2) Doorbell Brick Extension - 5/8" Offset

This mount is a Standard 5/8in Offset brick extension mount for the RING Wired Doorbell Plus that was previously call Ring Pro. Does not fit  Pro2 or the new name of that doorbell is WIred Doorbell Pro. 

To identify this doorbell  that is now Called Wired Doorbell Plus (formally PRO) the back is black and has ridges.   The PRO2 now call Wired Doorbell Pro has a slighly curved back.

. In cases where the doorbell is located behind a thick brick wall or other obstruction, the extension can be used to move the button or doorbell to a location where it is visible and opposite the door.  It is available in various extension lengths.   If you cant mount your doorbell flat, or if something is in the way of the view, you can use this mount to correct it.   These mounts allow for wires to pass through the center.

THIS STANDARD OFFSET HAS A PART OF THE MOST OF THE DOORBELL OFFSET OVER THE BRICK WITH ABOUT 3/8" OF THE DOORBELL OVERHANGING ON THE DOOR SIDE.

This is made to put the doorbell past the bricks if your doorbell is mounted to trim.  It offsets the doorbell over the bricks and away from the door.  So if doorbell is too close to the swing of the door, this is what you will need.

This Mount fits this Doorbell found on Amazon (affiliate link below)

Ring Pro Original Doorbell

This mount is 9/16in wide, and will fit in most spots.  The normal offset is 5/8in away from the door.   This means the doorbell will overhang just a little (about a 3/8in) on the door side, and the rest will be over the mount and on the brick side.

I have options to fully offset the doorbell all the way to the edge of the mount if necessary.    It is a little more expensive than the standard offset option.

Ring Pro Full Offset Brick Extension

NORMAL COLOR is Black, if you need to purchase a different color, there will be a color change request listing to change the color.

Color Change Request

Be sure to send me a picture of your doorbell and where you want to mount it.    Message me by email at shop@doorbellmount.com or text me at 318-759-7425.  

All my mounts have holes to allow for wire passthrough.

****While 3D printing provides really good production quality parts, there are often imperfections that may be found on the prints. These do not impair the function and rarely affect the aesthetics. But if your not happy with the quality, please text, email, or message me before leaving a review.