Corner Doorbell Mount Angled 30º 1in Fixed Trim Narrow/Slim Mount for Video Doorbells

This is a slim fixed mount that Fits directly up in the corner and movers the doobell out at 30 degrees and 1in out from the corner.   (PICTURE MAY NOT MATCH YOUR DOORBELL)  3/4in wide - 2in Hole Spacing -  The center of the mount is offset .854 and there is only room for a 2in Doorbell.  If you have a Ring Gen 2 or Battery Doorbell you corner mount will need to be at least .25in off the wall for this mount to fit.   Also consider part of the doorbell may be in the walkway if your trim is narrow or it may hit the door.  PLEASE SEND PICTURES, and I can comment if it will fit.

ONLY 3/4 in wide -- FIT IN 98% of areas. Mount is 3/4in wide. and 2.5in long with 2in hole space. I have adapters for the other 2%, message me. I can customize for different extension lengths   

If you need to match  your hole spacing you can Purchase This Item

PLEASE. MESSAGE me a picture if you have a question about your installation.

NORMAL COLOR is Black, if you need to purchase a different color, there will be a color change request listing to change the color.

Color Change Request

All screws are included. Wires pass through the inside. Angle pieces are easily swapped out if you have the wrong angle of if you want to buy multiple angle pieces in case you don't know the angle.

My mount is 2.5in long and 3/4in wide. Holes can be slotted if you don’t know saving but they are normally 2 inches between the holes.  You can request a customization to change the holes  

This is printed in PETG and rated for outdoor use. Do not trust other sellers selling similar items using PLA.

Send me a text message at 318-447-7345 with a picture of your current doorbell if you would like to know if this one will fit. Or message me here on Etsy with the picture. You can get a faster response by text.

I can make these extend farther from the wall for additional cost (due to print time change). The smallest extension will be shipped if no requests are made. Also additional colors can be requested for additional cost - Black is standard color for all doorbells except Simplisafe and Wyze which the standard color is white. If you request a different color, charges will vary from 2 to $5. 

Let me know if you want a different hole spacing, I can custom the hole spacing. 

***3D printed materials printed from PETG are strong, impact resistant, and lightweight. Is is a similar material found in most plastic parts. PETG is a food safe material / non toxic. 3D printing although usually produces fanstastic results, there may be some blemishes that are hardly noticeable. If you are unhappy with the quality I will gladly replace it for free.